September 28, 2006

Home repair plumbing - Plumbing Noises: Noisy Water Pipes

Tip! There are more than 20 facilities throughout North America that are responsible for producing all the product lines and there are more than 3000 employees all with specialized training in the plumbing industry. So whether you are new to plumbing or an old pro they'll be able to assist you.

Q: Since we have been on higher water pressure from a new source, we are getting more noise in the pipes. Not banging or clunking, just more water moving through the system faster, kind of a "rushing" noise. The pipe into the house is plastic, then hooks into copper pipe. The noise reverberates down the whole line, and since the pipe is strapped to the floor joists, it makes the noise under the kitchen, bathroom and one bedroom. I know about having a foot or so of capped pipe going up from a line to trap air and cushion the noise of "on" and "off" clunking, but this has me stumped. I am at the point now where I am about ready to rip the strapping off and putting foam around the pipes before I strap them back up. Before I spend the money on this, I thought I would check with you to see if that is what I need to do, or can you suggest something else ? Thanks very much.

A: A reduction of 1.5:1 (typically 3/4" to 1/2" is commonly used to increase or maintain water pressure throughout a house. The theory is that, given constant supply pressure, restricting volume will increase velocity. Released pressure at a fixture will be compensated for by this increased velocity.

Tip! Carl has been a professional plumber in a company he owns for more than 10 years not only is he experience in unclogging just about anything but also an expert in installing plumbing fixtures and installing new water lines. Carl will give you some helpful tips on plumbing installation when you visit http://www.

I expect your hot and cold supply pipes are 1/2 inch diameter. What diameter is the plastic feed? If the reduction is greater than 1.5:1 it's quite likely that the velocity is great enough to cause noise in the pipe.

Check that all the shut-off valves (below the sinks etc.) are completely open. They too, can cause turbulence/noise by restricting water flow. Also, check all the pipes to see if there are any crushed or dented sections.

Foam wrap is a great for insulating purposes, but perhaps a little too soft for noise damping (it would crush flat). By all means, wrap the pipes, but use denser rubber for vibration pads. Extra bracing (for clamping to) might also help.

Tip! Pillagers are those people who sneak around thieving from you. They seem to have an instinctive nose for any Plumbing contractor in business who is not minding his business.

Alternative: Before you start pulling out nails, check the water velocity at your fixtures, and if it is extremely high, a pressure reducing valve can be installed on the supply line.

Gil Strachan is a professional home inspector, representing Electrospec Home Inspection Services in east-central Ontario, Canada since 1994. Visit http://www.allaroundthehouse.com to learn more about home inspections.

"The Home Reference Book" You can probably find a home inspection for a little less than what we ask, but you probably won't find the Home Reference Book. A $60 value, this solutions-oriented reference tool comes free with every inspection we perform. It's the first tool you should have around the house!

National Plumbing Codes Handbook

National Plumbing Codes Handbook Thoroughly revised and updated version of the standard code book for the plumbing industry. The National Plumbing Codes Handbook covers the BOCA, UBC, and SPC codes, explaining the latest code specifications for procedures, installations, materials, and documentation. New features: eight new chapters and three new appendices…troubleshooting information…math calculations and business forms, and much more.